After the drying
Mold Inspection & Testing in Oswego, NY
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.
Independent local crews · scoped at the property
On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.
Often needed alongside
- Mold Remediation
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
Why do multiple layers cause leaks?
Because water gets between them and travels. A single covering sheds water down its surface; layered coverings have gaps where one stops and the next begins, and water entering at a flashing can run sideways between courses before it finds a way down. The stain inside bears little relation to the entry point.
What about the deck underneath?
It is the unknown in every one of these. Any rot that existed when the second layer went on is still there, covered rather than repaired, and it has continued. That is why a re-roof on a house like this frequently turns into a deck replacement once the layers come off.
Does the weight actually matter here?
It does with this much snow. Two extra layers of asphalt add a real load to the framing before anything falls on it, and the roofs here carry snow for months. It is one of the reasons stripping to the deck rather than adding another layer is the right decision in this climate.
This FAQ belongs to the Oswego page; it is repeated here.