After the drying
Mold Inspection & Testing in Dunkirk, NY
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.
No obligation: the assessment comes before any scope
On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.
Often needed alongside
- Mold Remediation
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
How does an awning put water into the wall?
Through the fixings that hold it up. Each one is a screw or a lag driven through the siding into the framing above the window, and whatever sealed those has long since gone. Water running down the wall finds the holes, and an awning that is holding snow keeps a wet band in exactly that place for months.
Where does the damage show up?
Under the window rather than over it. Water entering at the fixings runs down inside the wall cavity and collects at the first horizontal it meets, which is usually the window's own framing. Staining on the wall below the sill and soft trim at the corners are the usual first signs.
Is taking the awnings off the answer?
Sometimes, but only with the holes dealt with. Removing an awning leaves a row of penetrations in the siding that will keep passing water if they are simply left. The fixings come out, the holes are sealed, and if the awning goes back it is worth putting it back on new flashing rather than on sealant.
These questions come from the Dunkirk page.