Albuquerque neighborhood
Water Damage Restoration in Silver Hill, NM
My Water Damage and Restoration routes calls from Silver Hill and the rest of Albuquerque to independent local water damage contractors. Serving Albuquerque and the surrounding area, including Martineztown-Santa Barbara, Old Town, Los Candelarias, Netherwood Park, Los Duranes, Silver Hill, Barelas, Los Griegos.
- Around-the-clock response for standing water
- Independent local contractors, routed by city
- Scoped and quoted on site by the contractor who visits
- IICRC S500 drying: the standard to hold any contractor to
Services available in Silver Hill
The same call reaches an independent contractor for each service below in Silver Hill.
Water damage restoration
- 24/7 Emergency
Emergency Water Extraction
Standing water is pumped and extracted around the clock, before it climbs the walls and soaks the subfloor. Same-day response where coverage allows.
Learn more - Fast Response
Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Learn more - 24/7 Emergency
Storm & Flood Recovery
The opening is closed, the water is extracted, materials floodwater touched come out, and the structure is dried and rebuilt in that order.
Learn more - Fast Response
Groundwater & Basement Intrusion
Basement seepage, failed sumps and water through the slab are extracted and dried, and the path from the ground is found so the floor stays dry next season.
Learn more - Scheduled
Ceiling & Roof Leak Water Damage
The leak is traced above the stain and corrected, wet insulation comes out, the cavity is dried to a reading, and only then is the ceiling repaired.
Learn more - 24/7 Emergency
Sewage & Contaminated Water Cleanup
Sewage and black-water losses are contained, the materials the water touched are removed and disposed of, hard surfaces are disinfected, and the space is dried to a reading.
Learn more
Mold
- After the drying
Mold Inspection & Testing
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches.
Learn more - Contained removal
Mold Remediation
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.
Learn more
What drying runs into in Albuquerque
Serving Albuquerque and the surrounding area, including Martineztown-Santa Barbara, Old Town, Los Candelarias, Netherwood Park, Los Duranes, Silver Hill, Barelas, Los Griegos.
Local housing stock
The typical Albuquerque house dates to 1982, with close to three fifths of the stock (61.8 percent) built before 1990, so the assemblies that get wet are mostly early 1980s work. Slab-on-grade houses with stucco over frame or block, flat or low-pitch roofs, and tile or concrete floors are the ordinary stock, so a loss is usually a roof or an evaporative-cooler line rather than a basement, and the drying runs on the ceiling cavity and the slab in air that helps at every step.
Climate & seasonal risk
5 months in Albuquerque have normal lows below freezing, December the coldest at 20.6 degrees. The rain side of the calendar peaks in July at 1.81 inches of an annual 10.3; rain recorded at ALBUQUERQUE 1.7 SSE 2.1 miles away and temperatures at RIO GRANDE NATURE CTR 2.7 miles away. With barely ten inches of rain a year and dry air in every month, a sealed room here reaches the dry standard faster than almost anywhere, while five months of freezing lows put rooftop cooler lines and exposed supply lines on the winter calendar.
How water losses tend to end in Albuquerque
- Flat roofs ponding a July monsoon storm, so the ceiling cavity is opened and the soaked insulation comes out before the roof is patched
- Rooftop evaporative-cooler lines splitting in a freeze or leaking in spring, so the ceiling below is dried before the unit is reconnected
- Tile over a wet slab hiding a plumbing leak, so the floor is lifted where the slab reads wet and the concrete is dried directly