After the drying
Mold Inspection & Testing in Paterson, NJ
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.
Quoted on site by the contractor who visits
On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.
Often needed alongside
- Mold Remediation
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
How far does water travel on an open mill floor?
Much further than in a partitioned building, because there is nothing to stop it. A large open plate lets water run to the low corner and under whatever covering is down, so the wet area is frequently the whole floor rather than a room. It is mapped with a meter across the entire plate before anything is lifted.
Do the timber beams have to be replaced?
Very rarely. Heavy timber takes water slowly and releases it slowly, and it has far more material than modern framing, so it usually survives well. What it does do is read wet long after the finishes around it are done. The meter goes into the timber and the equipment stays until those numbers stop moving.
Can a thick plank floor be dried in place?
Often, if both faces can be reached. Plank floors give up water from the top and the underside, so opening the ceiling below lets air work on the back of the assembly and roughly halves the time. Where the ceiling below cannot be opened, the drying runs from one side only and takes considerably longer.
The same questions, in context, on the Paterson city page.