Skip to content
My Water Damage and Restoration Kannapolis logo
Containment poles and a negative-air machine coming off a van, the setup for removing growth without spreading it.

Contained removal

Mold Removal & Remediation in Kannapolis, NC

Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in. The area is sealed and put under negative air, affected porous material comes out, and what remains is cleaned and treated. The assembly is then dried and read to the same standard as any water loss before it is closed, because remediation over a still-wet assembly puts the same growth back behind new drywall.

Quoted on site by the contractor who visits

Remediation here is the tail of a water job: growth is what an unfinished drying leaves behind, and removing it without finishing the drying puts it back. The contractor establishes how far the growth extends and what moisture is still feeding it, removes what grew, and dries and reads the assembly before it is closed. The service note below covers the sequence in this city.

Often needed alongside

  • Mold Inspection & Testing

    An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches.

  • Structural Drying & Dehumidification

    Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.

A contractor at the door walking a homeowner through what comes out, what gets cleaned, and when the wall closes up.
A contractor setting expectations with the homeowner.

Frequently asked questions

What is the void under the bath?

A box-out formed in the slab when it was poured so the drain could be connected from below. Once the plumbing was in, most of them were simply covered over rather than filled, so there is a hollow in the concrete under the tub with the connection inside it.

Why does a void under the tub matter?

Because it collects. A drain that weeps puts water into a closed hollow rather than onto a floor where it would be seen, and it stays there with no ventilation. By the time anything appears in the room, the void has been holding water for a long time.

How is the box-out reached?

By taking the tub out, which is most of the work. There is no access to a box-out from anywhere else, and the readings on the floor around it are unhelpful because the water is below the slab surface rather than in it. The bathroom comes apart to see it.

The Kannapolis overview carries this FAQ with the city research.

Need mold remediation in Kannapolis now?

Call (833) 243-4415
Call a Local Pro — (833) 243-4415