After the drying
Mold Inspection & Testing in Durham, NC
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.
Local contractors · findings documented for your claim
On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.
Often needed alongside
- Mold Remediation
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
Does brick veneer hold water at the bottom of the wall?
It can, at the base course where the veneer meets the foundation. Brick absorbs and the cavity behind it drains to weep holes, so if those are blocked the water sits against the sheathing instead of leaving. After an interior loss the wall base is read from inside, and if the readings stay high once the room is dry the outside is looked at before the wall closes.
Why is the crawl space damp before the loss even happened?
Because ventilated crawl spaces here draw in warm, moist air through most of the year, and that air condenses on cooler surfaces underneath. By September the space has been humid for months. A loss on top of that starts from a worse position, which is why the drying plan treats the whole space rather than just the wet spot.
What happens to wet underfloor insulation?
It comes out. Batt insulation between floor joists holds water against the subfloor, loses its shape once saturated and sags away from the framing, and it will not dry in place in a closed crawl space. It is removed so the joists and subfloor can be read directly and dried, then new insulation goes in once those readings hold.
The same questions, in context, on the Durham city page.