Serving Bozeman
Structural Drying & Dehumidification in Bozeman, MT
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material. The wet area is sealed, air movers and dehumidifiers run as one system, and the material is read at marked points every day against a dry standard from an unaffected room. The equipment leaves on the readings rather than on a date, and the final readings are logged so the rebuild starts on a documented dry structure.
Quoted on site by the contractor who visits
Often needed alongside
- Emergency Water Extraction
Standing water is pumped and extracted around the clock, before it climbs the walls and soaks the subfloor. Same-day response where coverage allows.
- Mold Inspection & Testing
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches.
Frequently asked questions
How is a leak in the floor heating found?
By pressure first and by heat second. The system is isolated and watched to confirm it is losing, and then the floor is surveyed for the temperature pattern, because a leak in warm tubing shows as a warm area. That narrows it to a small region before any concrete is cut.
Why does the house get cold rather than wet?
Because the water goes into the slab rather than into the room. A failure in embedded tubing loses pressure and the system stops working properly, so the first thing anyone notices is that the heating is not keeping up. The water is in the floor the whole time.
What happens when the slab is cut to reach it?
Cutting into the slab at the point the survey identified, which also cuts the tubing, so the repair and the access are the same operation. It is precise work and it is why the locating stage is done carefully; a rough estimate means a much larger opening than necessary.
This FAQ belongs to the Bozeman page; it is repeated here.