After the drying
Mold Inspection & Testing in Laurel, MS
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.
The pro who inspects is the pro who quotes
On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.
Often needed alongside
- Mold Remediation
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
What is under these floorboards?
The joists, and then the crawl space. There is no plywood or plank subfloor between, which is normal in houses of this age here. The finished floor is also the structural deck, and it is the only layer separating the room from the space below.
Does water on the floor stay on the floor?
Very little of it. Boards laid directly on joists have gaps between them that open further with age, so a spill or a burst upstairs goes through into the crawl space rather than spreading across the room. Less shows above and more ends up below.
Is the old flooring worth saving?
Nearly always, and it changes the whole approach. Heart pine of this age cannot be replaced with anything comparable, so the work is patient drying from both sides with the boards left in place, which takes longer than replacement and is worth it.
This FAQ belongs to the Laurel page; it is repeated here.