After the drying
Mold Inspection & Testing in Florissant, MO
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.
Independent local crews · scoped at the property
On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.
Often needed alongside
- Mold Remediation
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
A ceiling tile fell and there is water above it. What happens first?
The grid comes down over the wet area and the floor structure above is read. Tiles hold water and hide the bays completely, so the extent is unknown until they are out. Wet tiles are discarded rather than dried. The joists and subfloor above are then checked with pins, and the wall below is read at its base.
Why does a spring loss in the rec room run past the estimate?
Eight to twelve days, and the season is the reason. The concrete is still carrying winter temperature while the outside air has turned humid, so any ventilation condenses onto the floor and walls. The room is sealed and dehumidified, the wall bases are opened to reach the poured concrete, and readings are taken on the concrete itself.
Why open the bottom of the wall when the water came from the ceiling?
Because that is where it ended up. Water that comes through a ceiling runs down the face of the board or inside the furred cavity and collects at the floor, where the bottom plate sits on concrete. A low opening lets the plate, the cavity and the wall behind be read and dried. Without it the wall is being guessed at.
This FAQ belongs to the Florissant page; it is repeated here.