24/7 Emergency
Storm & Flood Damage Recovery in Minneapolis, MN
The opening is closed, the water is extracted, materials floodwater touched come out, and the structure is dried and rebuilt in that order. The opening is closed first, with tarps or board-up, so the building stops taking on water. Floodwater is extracted, and the porous materials it touched come out rather than dry, since it crossed ground outside. The structure is dried and re-read, and the rebuild waits until the readings and the roof both allow it.
Independent local crews · scoped at the property
Often needed alongside
- Emergency Water Extraction
Standing water is pumped and extracted around the clock, before it climbs the walls and soaks the subfloor. Same-day response where coverage allows.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
- Sewage & Contaminated Water Cleanup
Sewage and black-water losses are contained, the materials the water touched are removed and disposed of, hard surfaces are disinfected, and the space is dried to a reading.
Frequently asked questions
An ice dam put water in the wall. What has to be opened?
The top of the wall, usually, and the ceiling near the eave. Meltwater from an ice dam gets behind the siding and runs down inside the cavity, so the wet insulation comes out and the studs and the back of the plaster are dried from inside. The contractor reads the cavity until it holds a dry standard, and the roof edge is corrected before the wall is closed.
Does a January leak dry faster than a June one here?
Yes, once the line is fixed. Heated winter air in Minneapolis is very dry, so a sealed room with air movers and a dehumidifier reaches the readings in a few days. June brings the heaviest rain and the humid stretch of the year, and a basement loss then runs longer for the same water. The cold causes the winter losses; it does not slow the drying afterward.
Can the plaster upstairs be dried without cutting it out?
Almost always. Plaster over lath is dense and dries slowly, but it dries, and cutting it is the last resort. The contractor drills at the base of the wall to move air behind it, keeps the room sealed, and reads the lath until it reaches the standard, which takes two or three times the drywall timeline. Painting before that traps the moisture.
Open the Minneapolis FAQ beside the housing and climate notes.