After the drying
Mold Inspection & Testing in Lakeville, MN
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.
Local contractors · findings documented for your claim
On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.
Often needed alongside
- Mold Remediation
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
What is the sheet behind the wall board?
A vapor barrier on the warm side of the insulation, standard for a climate with five months below freezing. It stops indoor moisture reaching the cold part of the wall in winter, which is exactly what you want. After a loss it becomes the reason a wet cavity has no way to dry toward the room.
Does that mean the wall has to be opened every time?
Where the cavity is wet, yes. There is no drying a sealed bay from the room side, because the sheet is doing precisely what it was installed to do. The board and the sheet come off along the wet run, the insulation comes out, and the bay is dried open before it is rebuilt.
Why does the wall surface read dry?
Because the board is not in contact with the wet part. The sheet separates the finish from the insulation and the framing behind it, so a surface meter reports a dry face over a saturated bay. Readings have to go past the barrier, and where there is any doubt the wall is opened rather than trusted.
Read it with the local conditions on the Lakeville page.