Skip to content
My Water Damage and Restoration Quincy logo
Containment poles and a negative-air machine coming off a van, the setup for removing growth without spreading it.

Contained removal

Mold Removal & Remediation in Quincy, MA

Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in. The area is sealed and put under negative air, affected porous material comes out, and what remains is cleaned and treated. The assembly is then dried and read to the same standard as any water loss before it is closed, because remediation over a still-wet assembly puts the same growth back behind new drywall.

Quoted on site by the contractor who visits

Remediation here is the tail of a water job: growth is what an unfinished drying leaves behind, and removing it without finishing the drying puts it back. The contractor establishes how far the growth extends and what moisture is still feeding it, removes what grew, and dries and reads the assembly before it is closed. The service note below covers the sequence in this city.

Often needed alongside

  • Mold Inspection & Testing

    An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches.

  • Structural Drying & Dehumidification

    Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.

A contractor at the door walking a homeowner through what comes out, what gets cleaned, and when the wall closes up.
A contractor setting expectations with the homeowner.

Frequently asked questions

How close to the surface is the ledge here?

Rock, generally, and not much else. The excavation went down until it met ledge and the slab was poured on top of it, so there is no gravel layer and no soil for water to drain into. The floor sits on solid stone.

Where does the water come from, then?

Along the top of the rock. Water moving down through the soil stops when it reaches ledge and then runs sideways along the surface of it, which can bring it under a floor from a long way off. It is not arriving from directly below.

Why can a sub-slab system not be installed?

Because there is nothing to put one into. A drainage system under a floor needs a layer of stone to work in, and here the slab is on rock. The work goes to the outside of the building and to managing water before it reaches the ledge.

The Quincy overview carries this FAQ with the city research.

Need mold remediation in Quincy now?

Call (833) 243-4415
Call a Local Pro — (833) 243-4415