Contained removal
Mold Removal & Remediation in New Orleans, LA
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in. The area is sealed and put under negative air, affected porous material comes out, and what remains is cleaned and treated. The assembly is then dried and read to the same standard as any water loss before it is closed, because remediation over a still-wet assembly puts the same growth back behind new drywall.
The pro who inspects is the pro who quotes
Remediation here is the tail of a water job: growth is what an unfinished drying leaves behind, and removing it without finishing the drying puts it back. The contractor establishes how far the growth extends and what moisture is still feeding it, removes what grew, and dries and reads the assembly before it is closed. The service note below covers the sequence in this city.
Often needed alongside
- Mold Inspection & Testing
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
How long does an old pine floor take to dry compared with the walls?
Usually much longer. Heart pine is dense and holds water deep in the board, so it cups early and releases moisture slowly. Rather than tear out wood that is hard to replace, the contractor runs drying mats on the floor and keeps reading it after the plaster walls have already reached the dry standard, sometimes for weeks.
The rooms are dry but the house still smells damp. Where is the water?
Very often under the floor. A raised house keeps its living floor above a loss, but the bay between the piers fills and stays wet against the joists. The contractor opens the crawl, removes any soaked insulation, runs air and dehumidification underneath, and reads the joists and subfloor from below until they are dry.
Can plaster walls be dried in place, or do they come out?
Plaster over lath usually dries in place, but slowly. It is dense, so surfaces read dry while the lath behind still holds water, and closing it early is how stains and growth come back. The contractor drills at the base to move air behind the plaster and keeps reading until the lath reaches the standard, which can be two or three times the drywall timeline.
The same questions, in context, on the New Orleans city page.