Skip to content
My Water Damage and Restoration Kansas City logo
A contractor arriving with a meter case and a flashlight rather than drying equipment, there to look before anything is opened.

After the drying

Mold Inspection & Testing in Kansas City, KS

An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.

No obligation: the assessment comes before any scope

On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.

Often needed alongside

  • Mold Remediation

    Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.

  • Structural Drying & Dehumidification

    Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.

A homeowner at the door describing a smell that came back after a leak while the inspector listens.
An independent contractor, walking the homeowner through what he found.

Frequently asked questions

The meter gives different numbers along the same wall. Which is right?

Both, probably. These walls have usually been patched over the years, so a section of original plaster can sit beside a section of board, and the two materials read and behave completely differently. Readings are taken in each material and interpreted separately rather than averaged, which is what makes a mixed wall confusing.

Can part of a wall be removed and part kept?

It happens routinely here, and it looks odd until you know why. Plaster on lath usually survives a soaking and is worth drying; paper-faced board that stood in water is finished. The removal line follows the material rather than the room, so a wall can end up half opened and half intact.

What is found behind these walls when they come open?

Whatever the last repair left. Sometimes an empty bay, sometimes old fill, sometimes a previous patch closed over damp framing. It is read with pins as it is exposed rather than assumed from the room next door, and the scope frequently grows once the first section is open, which is worth expecting.

This FAQ belongs to the Kansas City page; it is repeated here.

Need mold inspection & testing in Kansas City now?

Call (833) 243-4415
Call a Local Pro — (833) 243-4415