After the drying
Mold Inspection & Testing in Greenleaf, KS
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.
No obligation: the assessment comes before any scope
On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.
Often needed alongside
- Mold Remediation
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
The cellar wall has always been a bit damp. Is this different?
It is a matter of degree and the meter settles it. A wall laid without damp proofing carries some moisture as its normal condition, so the useful question is not whether it is damp but whether the reading is falling. A baseline is taken away from the loss, and the affected section is dried until it matches that rather than until it reads bone dry.
How long does an old stone cellar wall take?
Longer than anything fastened to it, and the joints are slowest. Stone and lime mortar hold water deep in the wall and give it up through the face over days. Nothing is refastened against it until the base readings hold steady, because furring fixed to a damp wall traps the moisture behind it and starts the problem again.
Does older framing dry differently from new lumber?
It is slower both ways. Dense old dimensional stock takes water in more slowly than modern framing and lets it go more slowly too, so it can still read wet days after the surfaces around it have finished. It generally survives well. The meter goes into the wood itself and the equipment stays until those numbers stop moving.
These questions come from the Greenleaf page.