After the drying
Mold Inspection & Testing in Richmond, IN
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.
No obligation: the assessment comes before any scope
On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.
Often needed alongside
- Mold Remediation
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
The stain is at the bottom of the wall but the leak was at the roof. Why?
Because in a balloon-framed house the stud bays run unbroken from the sill to the attic, with nothing to stop water part way. It falls the full height inside the wall and shows where it finally pools. The bay is opened at the bottom and followed upward with a meter until dry framing is found, which is often several floors up.
What is in these wall cavities and does it come out?
Older walls here frequently hold loose fill rather than batts, and it comes out where it is wet. Loose material packs against the studs, holds water and cannot be dried in place or reliably read through. Once it is removed the bay is open to moving air, the studs are read directly, and new insulation goes in after the framing holds.
How much of a wall has to be opened to dry a bay?
Enough to reach the full wet height, which is decided by meter rather than by eye. Opening at intervals up the bay is common: a cut low, a cut at the wet line found above, and so on until the readings come back dry. Opening only at the stain leaves the upper part of the bay wet and closed.
The Richmond overview carries this FAQ with the city research.