Skip to content
My Water Damage and Restoration Fort Wayne logo
Containment poles and a negative-air machine coming off a van, the setup for removing growth without spreading it.

Contained removal

Mold Removal & Remediation in Fort Wayne, IN

Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in. The area is sealed and put under negative air, affected porous material comes out, and what remains is cleaned and treated. The assembly is then dried and read to the same standard as any water loss before it is closed, because remediation over a still-wet assembly puts the same growth back behind new drywall.

Independent local pros · containment before removal

Remediation here is the tail of a water job: growth is what an unfinished drying leaves behind, and removing it without finishing the drying puts it back. The contractor establishes how far the growth extends and what moisture is still feeding it, removes what grew, and dries and reads the assembly before it is closed. The service note below covers the sequence in this city.

Often needed alongside

  • Mold Inspection & Testing

    An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches.

  • Structural Drying & Dehumidification

    Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.

A contractor at the door walking a homeowner through what comes out, what gets cleaned, and when the wall closes up.
Findings first: what is there, and what it will take.

Frequently asked questions

Why does a porch roof leak at the wall?

Because that is where the water has to get past the building. A porch roof pitched this gently moves water slowly, and at the top it meets the house wall, where a strip of flashing tucked up behind the siding is the only thing turning it back out. Everything depends on that strip.

Why does the damage appear indoors rather than on the porch?

Because the junction is above the porch ceiling and inside the wall. Water getting past the flashing is already behind the siding at that point, so it runs down within the wall of the house and shows in a room, while the porch below it stays perfectly dry.

What does putting that flashing right involve?

Taking the siding off above the porch roof for a course or two, which is more work than it sounds and a good deal less than replacing a roof. The flashing is renewed and lapped properly under the wall covering, and it is worth doing while anything else is open up there.

These questions come from the Fort Wayne page.

Need mold remediation in Fort Wayne now?

Call (833) 243-4415
Call a Local Pro — (833) 243-4415