After the drying
Mold Inspection & Testing in Glenwood, IL
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.
Quoted on site by the contractor who visits
On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.
Often needed alongside
- Mold Remediation
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
Why were these converted?
To stop the street's sewer backing up into basements. Disconnecting everything below grade from the main and lifting it up to a discharge point above means the sewer cannot come back down the same route. It solved that problem completely and created a dependence on a pump.
What happens when that pump stops?
Nothing below grade drains at all. The floor drain, the laundry and any basement fixture are all feeding a pit that is now filling, and there is no overflow route. A power cut during the same storm that is producing the water is the situation these systems are least able to handle.
What should be checked on an old conversion?
The pump's age, the check valve, and whether there is any backup. Many of these installations are original, which puts the equipment well past its service life. It is also worth knowing exactly what is connected to the pit, since that decides what stops working when it fails.
Read it with the local conditions on the Glenwood page.