Serving Flossmoor
Structural Drying & Dehumidification in Flossmoor, IL
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material. The wet area is sealed, air movers and dehumidifiers run as one system, and the material is read at marked points every day against a dry standard from an unaffected room. The equipment leaves on the readings rather than on a date, and the final readings are logged so the rebuild starts on a documented dry structure.
Quoted on site by the contractor who visits
Often needed alongside
- Emergency Water Extraction
Standing water is pumped and extracted around the clock, before it climbs the walls and soaks the subfloor. Same-day response where coverage allows.
- Mold Inspection & Testing
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches.
Frequently asked questions
What is in the ceiling of these houses?
The heating. Electric cable was laid into the plaster when they were built, so the ceiling is the radiant surface that warms each room rather than a finish over a void. There is no furnace and there are no ducts anywhere in the building.
What happens first when that ceiling gets wet?
The circuit is isolated, before anything else. A wet ceiling here has an electrical element buried in it, so power to that room's heating comes off and stays off until the assembly has been assessed. Nothing about the drying starts before that.
Can the ceiling be opened up?
Only carefully and usually not much. Cutting into it means cutting the heating for that room, which turns a ceiling repair into a heating replacement, so the preference is strongly toward drying in place from above where there is any access at all.
This FAQ belongs to the Flossmoor page; it is repeated here.