After the drying
Mold Inspection & Testing in Chicago Heights, IL
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.
Independent local assessors · no obligation to proceed
On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.
Often needed alongside
- Mold Remediation
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
Water came up at the floor drain. Is that handled differently?
Yes, because of what is in it rather than how much. Water that backs up from a drain is treated as contaminated, so porous material that it touched is removed rather than dried: pad, the bottom of drywall, and anything pressed board. The slab is cleaned and then dried, and the drying readings only start to matter once the removal is finished.
Why does the water spread from the middle of the room?
Because it entered at the low point in the slab instead of at a wall. A drain backup rises where the floor is lowest and runs outward from there, which puts the wet edge in the middle of the room and the wall bases wet on every side. The extent is mapped from the drain outward, not from the perimeter in.
Do the basement walls have to be opened after a floor loss?
The bottom of any framed partition standing on the slab does. Those walls sit directly in the water and wick it upward behind the drywall where no room air reaches, so a low cut opens the cavity and lets the plate be read. Masonry foundation walls that were not touched above the waterline are usually left and simply read at the base.
Read it with the local conditions on the Chicago Heights page.