After the drying
Mold Inspection & Testing in Nampa, ID
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.
Independent local assessors · no obligation to proceed
On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.
Often needed alongside
- Mold Remediation
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
How can an outside tap flood the inside of a house?
Because the valve is not where the handle is. These taps close a foot or more back inside the heated wall so the exposed part can drain and not freeze, which works as long as nothing is attached to it. When the outer section cannot drain, the split happens at the valve, inside the framing.
Why does it only show up in the spring?
Because the ice is what is holding it closed. The split happens in a hard freeze but the water does not go anywhere while the section is frozen, so nothing is seen. It appears the first time the tap is opened in warm weather, or when the freeze lets go, often months after the damage was done.
What is opened to deal with it?
The wall on the inside, below and around where the tap passes through. The water is released at the rim and runs down inside the bay, so the extent is downward rather than around the fitting. The board comes off along that run and the framing and insulation are read directly.
Open the Nampa FAQ beside the housing and climate notes.