Skip to content
My Water Damage and Restoration Roswell logo
Containment poles and a negative-air machine coming off a van, the setup for removing growth without spreading it.

Contained removal

Mold Removal & Remediation in Roswell, GA

Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in. The area is sealed and put under negative air, affected porous material comes out, and what remains is cleaned and treated. The assembly is then dried and read to the same standard as any water loss before it is closed, because remediation over a still-wet assembly puts the same growth back behind new drywall.

No obligation: the assessment comes before any scope

Remediation here is the tail of a water job: growth is what an unfinished drying leaves behind, and removing it without finishing the drying puts it back. The contractor establishes how far the growth extends and what moisture is still feeding it, removes what grew, and dries and reads the assembly before it is closed. The service note below covers the sequence in this city.

Often needed alongside

  • Mold Inspection & Testing

    An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches.

  • Structural Drying & Dehumidification

    Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.

A contractor at the door walking a homeowner through what comes out, what gets cleaned, and when the wall closes up.
An independent contractor, walking the homeowner through what he found.

Frequently asked questions

Do roof mounts leak?

They do when they are done badly, and the failure is not visible from the ground. Each mount is a lag bolt through the shingles into a rafter, sealed with a flashing that should be woven into the covering. Where sealant alone was used instead, it lasts a few years and then the penetration is open.

How would a leak at a mount show itself?

From inside, usually. Water entering at a mount runs down the underside of the deck and shows as a stain on the attic sheathing or a ceiling below, some distance from the point of entry. The panels themselves hide the roof surface, so nothing is apparent from outside at all.

What happens when the roof needs replacing?

The array comes off and goes back on, which is a cost worth knowing about in advance. It is also the one opportunity to see the deck under the panels. Where an installation went onto an older roof, that deck has frequently been taking water at a mount for years, and this is when it is found.

The same questions, in context, on the Roswell city page.

Need mold remediation in Roswell now?

Call (833) 243-4415
Call a Local Pro — (833) 243-4415