Contained removal
Mold Removal & Remediation in Augusta, GA
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in. The area is sealed and put under negative air, affected porous material comes out, and what remains is cleaned and treated. The assembly is then dried and read to the same standard as any water loss before it is closed, because remediation over a still-wet assembly puts the same growth back behind new drywall.
Independent local crews · scoped at the property
Remediation here is the tail of a water job: growth is what an unfinished drying leaves behind, and removing it without finishing the drying puts it back. The contractor establishes how far the growth extends and what moisture is still feeding it, removes what grew, and dries and reads the assembly before it is closed. The service note below covers the sequence in this city.
Often needed alongside
- Mold Inspection & Testing
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
How high is too high for a planting bed?
Any bed whose surface is above the floor inside is too high, and once it is within a few inches of the siding it is too high as well. The building was detailed to have a gap between the ground and the wall covering, and everything about how that wall sheds water depends on the gap still being there.
What does the buried wall actually do?
It takes up water and holds it. Brick weeps that were meant to drain the cavity are below the mulch line and cannot discharge; siding that was meant to end clear of the ground is sitting in wet material. Both put moisture into the structure behind them steadily rather than in an event.
Is lowering a bed a real fix?
It is most of one, and it is cheap. Cutting the bed back to expose the bottom of the wall and grading it to fall away restores the gap the building needs. The plants can be replanted lower; what should not go back is the practice of adding an inch of fresh mulch on top every spring.
Open the Augusta FAQ beside the housing and climate notes.