After the drying
Mold Inspection & Testing in Tamarac, FL
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.
No obligation: the assessment comes before any scope
On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.
Often needed alongside
- Mold Remediation
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
What does the schedule look like once the neighbor side is wet?
Plan on longer than a single home, largely for access rather than physics. The concrete behaves the same on both sides, but equipment has to be set in two households, readings taken in both, and neither side is finished until the other is. Ten days to two weeks is fair where both units were opened promptly.
Can vinyl plank over terrazzo be dried in place?
Almost never, because the plank is a vapor barrier laid on a floor that is already one. Water that gets between them has no way out at all, and the terrazzo underneath will hold it indefinitely. The plank comes up, the old floor is dried directly, and new covering goes down after the readings settle.
When can the base and the door casings go back on?
After the wall cavity reads dry, not after the drywall does. Block walls with furring behind the board hold moisture in the strips and against the masonry, and the surface reads dry well before that space does. Trim goes on last because taking it off again is destructive, so it waits for two or three steady readings.
These questions come from the Tamarac page.