After the drying
Mold Inspection & Testing in New Port Richey, FL
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.
No obligation: the assessment comes before any scope
On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.
Often needed alongside
- Mold Remediation
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
Does terrazzo come up after a loss?
Almost never. It is bonded to the slab, survives water well and is worth keeping. What it does is slow the slab from releasing moisture upward, so the drying is set up to pull from the edges and any opening already made. The floor is read with a meter rather than by eye before the base and cabinets go back.
Why does the floor keep reading wet at the walls?
Because the ground outside sits close to the level of the slab on these lots, so the perimeter is in damp soil and keeps being resupplied. The middle of the floor comes down normally while the edges lag. Those are read separately and the base trim stays off until they hold rather than until the room looks finished.
The block wall got wet. Does it have to be opened?
Not the block itself. Water sits in the hollow cores and leaves through the face, so the wall is dried in place with air moved across it. What comes off is anything fastened to it: furring, insulation board and the drywall, since those hold water against the block and slow the whole wall down.
These questions come from the New Port Richey page.