After the drying
Mold Inspection & Testing in Naples, FL
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.
Independent local crews · scoped at the property
On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.
Often needed alongside
- Mold Remediation
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
The house was empty and the leak ran for weeks. What has to come out?
Anything paper-faced or pressed-board that stood in water. Drywall wicks upward from the floor and cabinet boxes swell from the bottom edge, and after weeks neither dries back to a sound condition. Terrazzo and tile usually stay. The work is removal first, then drying the slab and the block behind the base, then rebuilding.
Does terrazzo have to come up after a leak?
Almost never. It is a hard surface bonded to the slab and it survives water well, but it also slows the slab underneath from releasing moisture upward. The drying is set up to pull from the edges and from any opening already made, and the floor is read with a meter rather than by eye before the base and cabinets go back.
Why is there still a smell after everything looked dry?
Usually because something absorbent was closed up while still damp. Cabinet toe-kicks, the back of a base run and the bottom of a wall cavity are the common places, and with lows near 56 degrees even in winter there is no cold, dry stretch to finish the job passively. Those areas are opened, dried and read before they are closed again.
This FAQ belongs to the Naples page; it is repeated here.