After the drying
Mold Inspection & Testing in Jacksonville, FL
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.
No obligation: the assessment comes before any scope
On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.
Often needed alongside
- Mold Remediation
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
Can a frame house on a crawl space be dried from underneath?
Yes, and often that is the better route. When a leak has gone through the floor, the contractor removes the wet insulation from between the joists, runs air and dehumidification in the crawl space, and reads the subfloor from below. The finished floor above may survive if it is reached early; the insulation underneath usually does not.
Why would a winter leak dry faster here than a summer one?
Because the winter air has room for moisture and the summer air does not. Jacksonville's wet season runs into September and keeps indoor humidity high, so dehumidifiers carry the load and runs are long. In the mild winter months the same equipment reaches the dry standard in days, and the scope is often smaller for the same water.
What happens to laminate flooring that took a leak?
It usually comes up. Laminate and floating floors trap water in the layer underneath, where it cannot be dried through the surface, and the planks swell along the joints within a day or two. The contractor lifts the floor, dries the slab or subfloor to a reading, and only then is a new floor laid.
The Jacksonville overview carries this FAQ with the city research.