After the drying
Mold Inspection & Testing in Hudson, FL
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.
No obligation: the assessment comes before any scope
On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.
Often needed alongside
- Mold Remediation
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
What is actually holding the water out at a window here?
The sealant round the frame, and very little else. The opening was formed in the block and the window set straight into it, so there is no buck, no surround and nothing behind the joint to catch what gets past. When that bead ages and opens, there is no second line.
Where does the water go once it is past?
Into the block itself. There is no cavity beside the opening to drain into, so it is absorbed by the masonry around the jamb and the sill and works its way down and inward through the wall. The inside shows it at the reveal and below the sill rather than at the point it entered.
Does resealing it deal with the problem?
It stops the source, which is necessary, but the wall still holds what it has taken. Block absorbs through its body and gives it back slowly from one face, so the masonry around the opening is read and dried after the joint is made good rather than assumed to be finished with it.
This FAQ belongs to the Hudson page; it is repeated here.