Contained removal
Mold Removal & Remediation in Boca Raton, FL
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in. The area is sealed and put under negative air, affected porous material comes out, and what remains is cleaned and treated. The assembly is then dried and read to the same standard as any water loss before it is closed, because remediation over a still-wet assembly puts the same growth back behind new drywall.
No obligation: the assessment comes before any scope
Remediation here is the tail of a water job: growth is what an unfinished drying leaves behind, and removing it without finishing the drying puts it back. The contractor establishes how far the growth extends and what moisture is still feeding it, removes what grew, and dries and reads the assembly before it is closed. The service note below covers the sequence in this city.
Often needed alongside
- Mold Inspection & Testing
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
The ceiling is wet and the roof is fine. Where is it coming from?
Most likely the deck above that room. A terrace built over living space has a waterproof layer under its tile, and once that fails the water is inside the deck structure rather than on top of it. It then finds a path down into the ceiling below, often some distance from wherever the membrane actually gave way.
Does the deck have to be taken up?
Usually, at least along the wet run. The membrane is buried under a mortar bed and tile, so it cannot be inspected or repaired from above without lifting the finish. It is also the only way to dry the fill underneath, which holds a great deal of water and will keep feeding the ceiling if it is left.
The surface has been patched. Why is the ceiling still wet?
Because the fill under the deck is still holding what it took in. Lightweight concrete soaks up a lot and releases it slowly downward, so sealing the top face only stops it getting worse. The deck is read with a probe and dried from below, and the ceiling stays open until both are steady.
Read it with the local conditions on the Boca Raton page.