After the drying
Mold Inspection & Testing in Norwalk, CT
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.
No obligation: the assessment comes before any scope
On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.
Often needed alongside
- Mold Remediation
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
The basement takes water every big storm. Is drying enough?
Drying handles this event; it does not handle the pattern. The wet material is removed and the assembly dried and read as usual. But a basement that fills whenever the tide and the rain coincide is telling you the water is arriving from outside, and the base readings after the job are the useful measure of whether that is still happening.
Why does the bottom of the wall stay wet longest?
Because it sits closest to a water table that does not go away between storms. The upper wall dries at a normal rate while the base keeps being resupplied from the soil, so the readings there fall more slowly and sometimes stall. That section is read on its own and the base trim stays off until it holds rather than until the room looks finished.
September rain on warm ground. Does that matter?
It does, because the ground has no capacity left. By the end of summer the soil is warm and already holding water, so heavy September rain runs rather than soaks and reaches foundations quickly. The same storm in a dry spring would largely disappear into the ground, which is why the storm season rather than the rainfall total drives the losses here.
The Norwalk overview carries this FAQ with the city research.