After the drying
Mold Inspection & Testing in Bristol, CT
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.
Quoted on site by the contractor who visits
On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.
Often needed alongside
- Mold Remediation
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
What is trap rock?
Hard volcanic rock, forming the ridges that run through this part of the state. It is dense and essentially impermeable to water, and in these neighborhoods it lies under a thin covering of soil rather than deep down beneath the surface.
Why does the ground flood so quickly?
Because there is so little of it. A foot or two of soil over rock holds very little water, so an autumn storm fills the profile within the first hour and everything after that runs across the surface, arriving at buildings in quantity.
Does a soakaway work here?
Almost never, and it is worth establishing that before paying for one. A pit dug into thin soil over trap rock has nothing to discharge into, so it fills and stays full. Drainage has to be piped to an outlet rather than put into the ground.
The same questions, in context, on the Bristol city page.