After the drying
Mold Inspection & Testing in Sunnyvale, CA
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.
Independent local crews · scoped at the property
On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.
Often needed alongside
- Mold Remediation
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
Where does the water go when the floor is flooded?
Into the ducts, through the floor registers. They sit at the lowest point of the room and open directly into a metal run inside the slab, so a loss that crosses the floor drains into the system within minutes. That is the part of the job that takes longest, because it is below everything and cannot be reached from the room.
Can the heating be used to help dry the house?
Not while the ducts are wet, and that is the awkward part. Running a system with standing water in it moves that moisture into every room instead of out of the building. The ducts are cleared and dried first, on their own, and the house is carried on portable equipment until the system is signed off.
What decides whether the ducts can stay?
How long they stood full and what came in with the water. Metal that held clean water briefly is cleaned and dried in place; a run that held water for days, or took anything from a drain, is a replacement, and replacing a duct inside a pour means cutting the floor. That decision is made early because everything else waits on it.
The Sunnyvale overview carries this FAQ with the city research.