Contained removal
Mold Removal & Remediation in San Jose, CA
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in. The area is sealed and put under negative air, affected porous material comes out, and what remains is cleaned and treated. The assembly is then dried and read to the same standard as any water loss before it is closed, because remediation over a still-wet assembly puts the same growth back behind new drywall.
Independent local crews · scoped at the property
Remediation here is the tail of a water job: growth is what an unfinished drying leaves behind, and removing it without finishing the drying puts it back. The contractor establishes how far the growth extends and what moisture is still feeding it, removes what grew, and dries and reads the assembly before it is closed. The service note below covers the sequence in this city.
Often needed alongside
- Mold Inspection & Testing
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
What is added when a second unit goes in?
A full set of services across the garden. Water, drainage and power are trenched from the house or the street to the back of the lot, and the new dwelling has its own kitchen and bathroom, so there is plumbing where there was lawn.
Why does the trench matter?
Because backfilled ground is looser than what surrounds it. A trench running from the street or the house to the back of the lot is a permeable line through otherwise settled soil, and winter rain finds it and follows it.
Where is the shutoff for the second unit?
Frequently nowhere obvious, which is worth establishing before it matters. Some installations put a valve at the branch and some do not, so a leak in the back unit may mean shutting off the whole property to stop it. A valve at the branch costs very little at the time of the build and a great deal to retrofit.
The same questions, in context, on the San Jose city page.