Skip to content
My Water Damage and Restoration San Francisco logo
A restoration contractor carrying drying equipment up a driveway from an open service van.

Measured Drying, Then Rebuild

San Francisco, CA Water Damage Restoration

Extraction, drying to a measured standard, and the rebuild after, for homes across San Francisco and the rest of California. One call reaches an independent local pro.

Call Now: (833) 243-4415 See Services

Scoped on site, not over the phone · no obligation

  • Any hour, including the ones nobody wants to call in
  • City by city routing, never a national crew
  • Whoever inspects is whoever prices the work
  • Ask for drying measured against IICRC S500, not days elapsed

  • 24/7 emergency response

    Any hour of any day, including the holiday weekend it usually happens on.

  • No lead form

    No lead form, no resale: one call, one contractor, one quote.

A referral network of independent water damage contractors, reached through one number, in every state.

Call (833) 243-4415
A contractor showing a homeowner a tablet at the door, explaining what has to come out and what can dry in place.
Readings, then scope, then removal - in that order, agreed at the door.

The four stages of a drying job

What the IICRC S500 standard lays out, in sequence. The equipment is the easy part; the order is what decides how much of each later stage there is to do.

  1. Step 1: Stop and remove

    The source is shut off, then free water is pumped and extracted. Every hour water stands, it climbs further into drywall and subfloor, so this stage sets the size of everything after it.

  2. Step 2: Open and map

    Baseboard, wet drywall and soaked insulation come out, and meters read the material behind them. The wet edge is marked where the moisture stops, not where the stain does.

  3. Step 3: Dry to a number

    Air movers and dehumidifiers run as a sealed system, and the same points are read daily. The equipment leaves when the readings reach the dry standard for that material, not on a set day.

  4. Step 4: Close up

    Rebuild starts only after the structure is confirmed dry. Insulation, drywall and finishes go back over an assembly that will not feed anything later.

San Francisco: what the drying job runs into

When a floor is wet in San Francisco, the call routes to an independent local contractor for water damage restoration, across town and out to Hayes Valley, Civic Center, and West SoMa. A great many houses here have been bolted down to their foundations since they were built, and that work opened walls.

How these houses are built

81.8 percent of San Francisco's housing was standing before 1990, around a median build year of 1946, and that era decides what a contractor finds once the drywall is off. Around a median of 1946 with more than eight in ten houses older, the older stock has been retrofitted to tie the frame to the foundation and brace the cripple walls, which means the lowest part of the structure has been opened and refixed.

The climate a job dries in

Drying here is a September job at one pace and a January job at another, 60.1 degrees against 52.4; the 30.03 inches a year peak in December at 6.21, rain recorded at BOLINAS 0.2 W 21.9 miles away and temperatures at SAN FRANCISCO OCEANSIDE 28.8 miles away. December is the wettest month at 6.21 inches of a 30-inch year and no month averages a freeze, so the rain arrives in a concentrated winter; the base of a wall that has been opened and closed again meets that every year after.

The way a loss ends here

  • Work concentrated at the base of the wall, so the repairs are where the water arrives
  • Retrofits of widely varying quality, so what was done depends entirely on who did it
  • Finishes replaced over new framing, so what is behind the wall is not the original

Water Damage Restoration services in San Francisco

Start with what is wet. My Water Damage and Restoration routes you to independent San Francisco contractors for extraction and drying, with mold inspection and remediation as the last stage of the same job.

Water damage restoration

Mold

Areas covered around San Francisco

Start from the California directory list for a nearby town.

Frequently asked questions

What does a seismic retrofit involve down there?

Bolting the sill to the foundation and sheathing the short cripple walls above it, which means opening up the lowest part of the structure, drilling the foundation, and closing it back up. It is done for shaking, not for water.

Why does retrofit work matter to a wet wall?

Because the work is exactly where water arrives. The sill, the cripple wall and the base of the framing are what a retrofit touches and what a wet garage or a leaking foundation reaches, so the two overlap completely. That overlap is the reason a retrofit inspection and a damp survey tend to find the same things.

Does the quality of the retrofit vary?

Enormously, and it is worth establishing which kind you have. Some were engineered and inspected; others were done quickly with whatever hardware was to hand. Opening one small area tells you which, and it changes what can be relied on.

San Francisco, CA

Standing water in San Francisco?

The call is free and it reaches a contractor who can have equipment running today. Nothing is owed for asking.

Call (833) 243-4415

Scoped on site, not over the phone · no obligation

Say where the water is and what it touched. The call routes to an independent pro covering your area; there is no form to fill and no callback queue.

  • What is wet: carpet, hardwood, drywall, a ceiling, a basement floor
  • Whether the water is still coming, standing, or already gone into the floor
  • How long it has been there, as best you can tell
  • Your city, so the call routes to a contractor who covers it
Call a Local Pro — (833) 243-4415