Skip to content
My Water Damage and Restoration San Diego logo
Containment poles and a negative-air machine coming off a van, the setup for removing growth without spreading it.

Contained removal

Mold Removal & Remediation in San Diego, CA

Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in. The area is sealed and put under negative air, affected porous material comes out, and what remains is cleaned and treated. The assembly is then dried and read to the same standard as any water loss before it is closed, because remediation over a still-wet assembly puts the same growth back behind new drywall.

Quoted on site by the contractor who visits

Remediation here is the tail of a water job: growth is what an unfinished drying leaves behind, and removing it without finishing the drying puts it back. The contractor establishes how far the growth extends and what moisture is still feeding it, removes what grew, and dries and reads the assembly before it is closed. The service note below covers the sequence in this city.

Often needed alongside

  • Mold Inspection & Testing

    An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches.

  • Structural Drying & Dehumidification

    Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.

A contractor at the door walking a homeowner through what comes out, what gets cleaned, and when the wall closes up.
A contractor setting expectations with the homeowner.

Frequently asked questions

What does canyon fill mean for a lot?

That the ground under it is man-made rather than natural. The upper end of a canyon was filled to create buildable land, so a lot can have twenty or more feet of placed fill under one part and undisturbed mesa under another.

Why does water come out partway down the slope?

Because it is following the old canyon floor. Water entering the fill travels down through it until it reaches the original ground surface underneath and then runs along that, surfacing where the old contour meets the new face of the slope.

How is the fill boundary found?

From the grading plans held by the city, which show the original contours and what was placed. It is worth requesting before any foundation work, because a footing bearing partly on fill and partly on native ground behaves badly in a wet winter.

These questions come from the San Diego page.

Need mold remediation in San Diego now?

Call (833) 243-4415
Call a Local Pro — (833) 243-4415