After the drying
Mold Inspection & Testing in Fresno, CA
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.
Independent local crews · scoped at the property
On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.
Often needed alongside
- Mold Remediation
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
Why does water in the garage reach the house?
Because it is the same slab. The garage floor and the house floor were cast in one pour with a step formed between them, so there is no joint or break where one stops and the other starts. Moisture taken into the concrete at the garage end travels through it.
Does the step not keep it out?
It keeps the water out and lets the moisture through, which is the distinction that matters. Standing water stays on the garage side because of the step, but the concrete beneath is continuous, so what the slab absorbs does not respect the level change at all.
How is the house side of the slab read?
From inside, at the floor near the step, and then back into the room. Readings are taken into the slab rather than off flooring, because a covering can be dry over concrete that is still carrying moisture through from the garage end.
This FAQ belongs to the Fresno page; it is repeated here.