Contained removal
Mold Removal & Remediation in Enterprise, AL
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in. The area is sealed and put under negative air, affected porous material comes out, and what remains is cleaned and treated. The assembly is then dried and read to the same standard as any water loss before it is closed, because remediation over a still-wet assembly puts the same growth back behind new drywall.
No obligation: the assessment comes before any scope
Remediation here is the tail of a water job: growth is what an unfinished drying leaves behind, and removing it without finishing the drying puts it back. The contractor establishes how far the growth extends and what moisture is still feeding it, removes what grew, and dries and reads the assembly before it is closed. The service note below covers the sequence in this city.
Often needed alongside
- Mold Inspection & Testing
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
What is the chamber under the fireplace?
An ash pit. There is an opening in the floor of the firebox that drops into a masonry chamber in the base of the chimney, with a small door to clear it from outside or from a crawl space. It is a closed void with no drainage in it.
Why does water end up in there?
Because it is the bottom of the chimney. Anything getting in at the top, at a cap or at flashing, runs down inside the masonry and the flue and collects at the lowest point, which is the pit. It can hold a considerable amount without anything appearing in the room.
How is it dried out?
It is emptied first, through the clean-out door, which usually has to be freed up before anything else can happen. After that the surrounding masonry is read and dried, because the chamber will have been feeding moisture into the base of the chimney and the floor around it for as long as it has been full.
Open the Enterprise FAQ beside the housing and climate notes.