After the drying
Mold Inspection & Testing in Auburn, AL
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.
Independent local assessors · no obligation to proceed
On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.
Often needed alongside
- Mold Remediation
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
The wall was dried in the spring. Why is it damp again in August?
It may not have been finished. A building held at a high setting through the summer runs humid inside, so an assembly that was closed while still carrying moisture has no way to release and no season working on it. The reading that matters is the one taken inside the cavity before it was closed, not how the room felt.
Does turning the cooling down help the drying?
It helps, though it is not the drying plan. A system running more takes some moisture out of the whole house, which supports the equipment. What it cannot do is dry a closed wall cavity. The value of it is in the months afterwards, when a slightly drier building is what stops a marginal job from coming back.
What is checked before a wall is closed here?
The cavity, on consecutive days, through the opening that was made to dry it. The surface reading is not the test. Where a building is going to sit closed and warm for months afterwards, the margin on that final reading matters more than it would somewhere with a dry season ahead.
Read it with the local conditions on the Auburn page.