Skip to content
My Water Damage and Restoration Brookfield logo
A contractor arriving with a meter case and a flashlight rather than drying equipment, there to look before anything is opened.

After the drying

Mold Inspection & Testing in Brookfield, WI

An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.

The pro who inspects is the pro who quotes

On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.

Often needed alongside

  • Mold Remediation

    Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.

  • Structural Drying & Dehumidification

    Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.

A homeowner at the door describing a smell that came back after a leak while the inspector listens.
What the inspection turned up, explained at the door.

Frequently asked questions

What is the line across the basement floor?

Where the slab was cut to put a drain in. Adding a bathroom to a basement means trenching through the floor to reach the main, and the trench is patched afterward, so there is a strip of newer concrete running across the room with a joint down each side.

Why does water come up along it?

Because the patch never bonded. Fresh concrete poured against a cured edge does not knit to it, so there is a joint on both sides of the strip running the length of the trench, and ground water under the slab finds that before it finds anything else.

Can the trench joint be sealed?

It can be filled, and it is worth doing, but a joint that water is being pushed up through will open again. Where the pressure from below is the real issue, dealing with the drainage outside or fitting a pump does more than sealing a line in the floor.

These questions come from the Brookfield page.

Need mold inspection & testing in Brookfield now?

Call (833) 243-4415
Call a Local Pro — (833) 243-4415