After the drying
Mold Inspection & Testing in Renton, WA
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.
Quoted on site by the contractor who visits
On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.
Often needed alongside
- Mold Remediation
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
How does a channel drain stop working?
By filling from the bottom. Grit, fir needles and moss wash down the drive into the channel and settle, and because the water still drains slowly nobody notices. Over a few wet seasons the channel is full to the grate, and then the first heavy storm finds nothing there to catch anything.
How is a channel drain checked?
Lift a section of the grate and look, which takes a minute. The channel should be empty below the grating with a visible fall toward the outlet. If it is packed with silt, or if water stands in it when nothing is running, it needs clearing and the outlet pipe needs checking as well.
What happens to the garage when it fails?
It takes the whole drive's runoff. A paved slope running from the street to a door is a collector, and the drain is the only thing between it and the building. When the channel is full, the water arrives at the door at the same rate it comes down the drive, which in November is considerable.
The same questions, in context, on the Renton city page.