Skip to content
My Water Damage and Restoration Bon Air logo
Containment poles and a negative-air machine coming off a van, the setup for removing growth without spreading it.

Contained removal

Mold Removal & Remediation in Bon Air, VA

Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in. The area is sealed and put under negative air, affected porous material comes out, and what remains is cleaned and treated. The assembly is then dried and read to the same standard as any water loss before it is closed, because remediation over a still-wet assembly puts the same growth back behind new drywall.

Quoted on site by the contractor who visits

Remediation here is the tail of a water job: growth is what an unfinished drying leaves behind, and removing it without finishing the drying puts it back. The contractor establishes how far the growth extends and what moisture is still feeding it, removes what grew, and dries and reads the assembly before it is closed. The service note below covers the sequence in this city.

Often needed alongside

  • Mold Inspection & Testing

    An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches.

  • Structural Drying & Dehumidification

    Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.

A contractor at the door walking a homeowner through what comes out, what gets cleaned, and when the wall closes up.
A contractor setting expectations with the homeowner.

Frequently asked questions

What are the weep holes for?

They are the way out. Brick is not waterproof and the skin outside these houses has a gap behind it precisely so that anything getting through can run down and leave through the openings in the bottom course. Without them the gap is a container.

How do they get blocked?

Mortar, mostly, dropped into the cavity as the wall was laid or smeared across the openings when the bottom course was pointed. On plenty of these houses they were never properly formed to begin with, and nothing about the wall shows it.

Can they be opened up again?

They can, and it is inexpensive next to what a wet wall base costs. Clearing the openings and fitting vents to keep them open restores the drainage the wall was designed around. It is routinely the first thing raised after a wall of this type is dried.

This FAQ belongs to the Bon Air page; it is repeated here.

Need mold remediation in Bon Air now?

Call (833) 243-4415
Call a Local Pro — (833) 243-4415