After the drying
Mold Inspection & Testing in Texas City, TX
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.
No obligation: the assessment comes before any scope
On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.
Often needed alongside
- Mold Remediation
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
The wet area is all around the outside walls. Why that pattern?
Because the water is coming in at the edge. Drives, patios and walks added over the years sit above the original floor level, so instead of running away, water is held against the slab perimeter. It enters at the edge and moves inward under the covering, which is why the middle of the room can look fine.
Is this a drying job or a drainage job?
Both, and it is worth being honest about that early. The drying deals with what is in the building now; the reason it happened is outside and will do it again. What the drying side can do is document where the water entered so the grading and the paving can be dealt with properly afterwards.
What is read before the base trim goes back on?
The plate and the slab at the perimeter, on consecutive days, and in more than one place. The floor edge is the last thing to come down here because the ground outside it stays wet, and a reading taken in the middle of the room says nothing useful about it. Trim waits for the perimeter numbers.
These questions come from the Texas City page.