After the drying
Mold Inspection & Testing in Denton, TX
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.
Quoted on site by the contractor who visits
On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.
Often needed alongside
- Mold Remediation
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
What is the ground like here?
A foot or two of sandy loam sitting on heavy clay. Water goes into the sand readily and then meets the clay and stops, so it collects at that boundary and runs along it rather than soaking on down the way it would in deeper sand.
Where does the perched water end up?
Against whatever interrupts the layer, which is usually a foundation. It arrives at shallow depth and from the side, so it reaches a slab edge or a footing rather than rising from below, and it can come from a good distance uphill.
Does the clay underneath still move?
It does, and that is what catches people out. The sand above it is stable and the clay below swells and shrinks, so a slab can be sitting on ground that looks and feels sound while the layer under it is working through a full seasonal cycle.
Open the Denton FAQ beside the housing and climate notes.