After the drying
Mold Inspection & Testing in Jackson, TN
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.
No obligation: the assessment comes before any scope
On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.
Often needed alongside
- Mold Remediation
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
Why is plumbing in the middle of the floor?
Because the island needed it. A sink or a dishwasher away from the walls has to be fed and drained from below, so the runs come up through the slab at that point rather than along a perimeter. It is the only practical route, and it puts a connection under concrete in the middle of the room.
How is a failure there located?
By testing rather than by looking. Nothing about the run is visible, so the supply and the drainage are isolated and checked separately to establish which has gone and roughly where. Opening the floor comes after that, and it is opened at the point the test indicates.
What does opening the floor involve?
Cutting and lifting the slab around the island, excavating the wet fill beneath and then reinstating it, which is most of the work. The kitchen has to come apart to reach it, so the drying plan is written after the floor is open rather than before, once the extent under the slab is actually known.
This FAQ belongs to the Jackson page; it is repeated here.