After the drying
Mold Inspection & Testing in Aberdeen, SD
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.
No obligation: the assessment comes before any scope
On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.
Often needed alongside
- Mold Remediation
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
Why does water stand against the house rather than running off?
Because there is nowhere for it to run to. The ground here is genuinely flat, so a lot has no fall in any direction, and roof water and snowmelt simply stay where they land. Against a foundation that means standing water rather than damp ground.
Does the spring melt make it worse?
Considerably, because the ground underneath is still frozen. Melt arriving on frozen soil cannot soak in, and with no fall it cannot run off either, so it sits on the surface against the building until the ground thaws enough to take it. That can be weeks.
What actually helps on flat ground?
Making a fall where there is none, which usually means bringing material in rather than cutting a slope. Building the ground up around the foundation for a few feet so that water has somewhere to go is the only thing that changes it, and it is the first thing discussed.
These questions come from the Aberdeen page.