After the drying
Mold Inspection & Testing in Warwick, RI
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.
No obligation: the assessment comes before any scope
On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.
Often needed alongside
- Mold Remediation
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
The floor is cold and the edges keep reading wet. Why?
Because a shallow slab sits close to the ground and takes its temperature and its moisture from the soil around it. The middle of the floor comes to the dry standard normally while the perimeter keeps being resupplied, so the edges are read separately and the base trim stays off until they hold. Closing early traps that moisture behind the wall.
Is the cabinet run saved or replaced after water across the floor?
It depends on the box material and how long it stood. Solid or plywood boxes usually come through; pressed board swells from the bottom edge and does not recover. Either way the kick is opened so the cavity behind can be dried and read, because that space holds water where nothing in the room reaches it and it is what causes a smell later.
There is no basement. Does that make it a smaller job?
Not smaller, just flatter. Without a cellar the water has nowhere to fall to, so it spreads sideways across the slab under the floor covering and reaches rooms that show nothing. The extent is mapped with a meter rather than by the visible edge, and the covering comes up across that whole area.
The Warwick overview carries this FAQ with the city research.