Contained removal
Mold Removal & Remediation in Pawtucket, RI
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in. The area is sealed and put under negative air, affected porous material comes out, and what remains is cleaned and treated. The assembly is then dried and read to the same standard as any water loss before it is closed, because remediation over a still-wet assembly puts the same growth back behind new drywall.
Quoted on site by the contractor who visits
Remediation here is the tail of a water job: growth is what an unfinished drying leaves behind, and removing it without finishing the drying puts it back. The contractor establishes how far the growth extends and what moisture is still feeding it, removes what grew, and dries and reads the assembly before it is closed. The service note below covers the sequence in this city.
Often needed alongside
- Mold Inspection & Testing
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
Why does a disused shaft matter?
Because it is still a hole through the building. Boarding it over at each floor closes the opening but leaves the shaft itself, so water getting into it on any level runs down through the structure to the bottom. It bypasses every floor it passes, which is why the damage turns up in the cellar.
How would anybody know it is there?
A shallow cupboard in the same corner of the kitchen on every floor is the usual sign, or a patched section of wall that lines up between levels. Old plans show them where they exist. Contractors working on these buildings find them when a wall is opened and there is nothing behind it.
What should be done with one that has taken water?
Open it at the lowest level and at the level where water entered, and dry it as a shaft rather than as a wall. It has no ventilation and no air movement, and the framing inside it has probably been wet before. Closing it back up without drying it puts the problem back where it was.
This FAQ belongs to the Pawtucket page; it is repeated here.