After the drying
Mold Inspection & Testing in Erie, PA
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.
Independent local assessors · no obligation to proceed
On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.
Often needed alongside
- Mold Remediation
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
What is the cavity beside the window frame?
The pocket the sash weights ran in. Windows of this age were hung on cords over pulleys with iron weights dropping into a void beside each frame, and that void runs from the head of the window down past the sill. Even where the sashes have been changed, the pocket is usually still open inside the wall.
How is water in a pocket like that found?
By opening the casing rather than by metering the wall. The pocket is a void, so a meter on the plaster or board beside it reads the finish and not the space behind, and the water sits at the bottom out of reach. The trim comes off at the jamb and the pocket is looked into directly.
Why does the damage show below the window rather than at it?
Because the void carries it down. Water entering near the frame drops the height of the pocket before anything stops it, so it arrives at the bottom plate and shows at the baseboard or in the room below. The stain marks the bottom of the cavity, not the point the water got in.
Open the Erie FAQ beside the housing and climate notes.