After the drying
Mold Inspection & Testing in East York, PA
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.
Quoted on site by the contractor who visits
On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.
Often needed alongside
- Mold Remediation
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
The basement floor is dry but something still smells. What is worth checking?
The pockets the steel columns stand in. They are shallow formed recesses in the slab, and water that spread across the floor runs into them and does not evaporate out. They are frequently packed with debris so nothing is visible, and they are the last wet thing in a basement that otherwise reads finished.
How is water got out of one?
By hand, and then with air directed into it. There is no drainage and no natural movement, so it is pumped or wicked out, any packing around the column is removed, and a small amount of air is directed down into the recess. It is a minor task that is easy to miss and causes a callback when it is.
Does the steel column matter after standing in water?
It is worth looking at rather than assuming. A pipe column base that has stood in water repeatedly corrodes at the bottom where it is least visible, and this loss may not be the first. The condition is noted while the pocket is open, because that is the only time anyone will see it.
The same questions, in context, on the East York city page.