After the drying
Mold Inspection & Testing in Butler, PA
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.
The pro who inspects is the pro who quotes
On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.
Often needed alongside
- Mold Remediation
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
Why does the back wing cause trouble?
Because it is a separate building attached to the first. It was put up later, usually on shallower footings, with its own roof running into the wall of the main house. Every part of that arrangement moves at a different rate from the house it is fixed to, and the joint between them opens.
What does a loss in that wing involve?
Different materials from the rest of the house, generally. These wings tend to have a thinner floor structure, a crawl or a slab rather than the cellar under the main block, and less insulation. The same volume of water behaves quite differently either side of that wall, so the drying is really two jobs.
What should be looked at first at the junction?
The flashing where the wing's roof meets the main wall, and the ground at the outside corner. Most of the water getting into these joints comes from that roof-to-wall line, and most of the movement comes from what the ground is doing under the wing. Both are visible from outside before anything is opened.
This FAQ belongs to the Butler page; it is repeated here.